Point

---

By defining points in a sketch, you can implement solid command operations such as holes.

Drawing Steps

1. Click to open the ，command of the point.

2. Click the left mouse button anywhere in the sketch to create a point.

3. End the command by the ESC key, or [Exit Point] in the right-click menu, or "Close" in the command bar.

Attribute Box

1. Left-click a point in the viewport to display its properties, as shown in the following illustration.

2. Existing Constraints：Displays constraints that were automatically added during sketching or generated using add constraints. When you select an item in the list, the corresponding element in the graphics area is highlighted.

3. Add Constraint：You can add a constraint to the selected element. The manifest contains only the constraints that the selected element might use.

4. Parameters：If there are no dimension constraints, you can change any value of the parameter (or extra parameter) to define a polyline. If there is a dimension constraint, the constrained element cannot be changed.